0
LEE cJ

As title, Boot and execute AT cmd ATWS log as below

But no any AT cmd response message feedback

Have anyone encounter same problem?

=========================================================

ROM Version: 0.3

Build ToolChain Version: gcc version 4.8.3 (Realtek ASDK-4.8.3p1 Build 2003) =========================================================

Check boot type form eFuse

SPI Initial

Image1 length: 0x3a18, Image Addr: 0x10000bc8

Image1 Validate OK, Going jump to Image1

BOOT from Flash:YES

===== Enter Image 1 ====

SDR Controller Init

load NEW fw 0

Flash Image2:Addr 0xb000, Len 283536, Load to SRAM 0x10006000

No Image3

Img2 Sign: RTKWin, InfaStart @ 0x10006051

===== Enter Image 2 ====

#interface 0 is initialized

interface 1 is initialized

Initializing WIFI ...

Start LOG SERVICE MODE

#

WIFI initialized

init_thread(53), Available heap 0xc440

AT_UART_CONF: 38400,8,1,0,0

RTL8195A[HAL]: ISR 81 had been allocated!!!

 

#

#

#

#

#

# ATWS

[ATWS]: _AT_WLAN_SCAN_ [MEM] After do cmd, available heap 55392

#

#

#

sean 回答了